Better Heating Lamps for Your Sidel and SIPA Blow Molders
If you’ve ever spent an afternoon fighting with a preform oven, you know the drill. You need that heat to be perfectly even, or you’re just staring at a pile of rejected bottles with wonky wall thickness. It’s frustrating. That’s why we make shortwave infrared lamps that actually fit. Whether you’re still running an old-school SBO or you’ve upgraded to the Matrix series, we’ve got you covered. No more “almost fits” There is nothing worse than a replacement lamp that’s a few millimeters off. You end up forcing it, stressing the quartz, and praying it doesn’t snap. We don’t do that. We build our tubes to the exact specs of the OEM lamps. They slide right into the reflectors without any fighting. It makes the swap fast. Really fast. Then there’s the power. We tune the voltage and wattage to match your machine’s power rail. If you want to push the wattage higher to speed up your cycle times, you can. Just a heads-up: make sure your cooling fans can handle the extra heat, or you’ll be dealing with a different kind of headache. Built to last (and stay put) We use heavy-wall quartz glass because thin glass burns out too fast under high heat. We also pay a lot of attention to the connectors—the R7s and SK15 types. We machine them for a tight, snug fit. Why? Because a loose connection creates arcs. Those arcs melt your sockets and kill your lamps. It’s a waste of money and time. Plus, we offer specific coatings that change how the heat hits the PET. It lets the energy soak deeper into the material without scorching the surface. Just plug and play The goal here is simple: a drop-in replacement. You shouldn’t have to rewire your machine or mess around with custom adapters just to get your oven running again. You just pull the old tube out, slide the new one in, and wire it up. It’s that simple. You get a consistent heat profile across the whole preform, and you stop wasting plastic on rejects.